![]() Prior releases are available at Signature To install OpenSCAD from git on Arch Linux the openSUSE packages built on OpenSUSE build service openSUSE Leap 15.3 (64-bit only) openSUSE Leap 15.4 (64-bit only) openSUSE Tumbleweed Fedora packages built on OpenSUSE build service Fedora 34 (x86_64, armv7l, aarch64, ppc64le) Fedora 35 (x86_64, armv7l, aarch64, ppc64le) Fedora 36 (x86_64, armv7l, aarch64, ppc64le) Fedora 37 (x86_64, armv7l, aarch64, ppc64le) Fedora Rawhide (x86_64, i586) Arch Linux OBS also supports HTTP links, but it's recommended to use In Debian/Ubuntu this is usually handled by theĪpt-transport-https package. The repository links below are shown as https, please check for your installation if This can be done by creating a newįile /etc/apt//openscad.list with the URL specific to the distribution. ![]() The new replacement for 123D Make is 'Slicer for Fusion 360.' You dont actually need Fusion 360 to use it, though. Its possible that its not logging in properly because of that. ![]() # wget -qO- | sudo tee /etc/apt//obs-openscad-nightly.ascĪfter the key is added, the repository URL needs to be configured. I cant say for sure if this is your problem, but the 123D Apps have been discontinued, including 123D Make. In this case the following command will download and store the key. In newer Debian the storage for the key is changed, more information can be found in the apt-key(8) NOTE: If you get errors about an expired key valid till, please re-import via the following command. To install the packages, the release key must be added with apt-key to the key-ring to allowĪpt-get / aptitude to validate the packages. Debian / Ubuntu packages built on OpenSUSE build service Install the development snapshot packages in parallel to the release versionįrom the official repositories. Note: The packages are called " openscad-nightly" so it's possible to The packages are automatically built based on the
0 Comments
Leave a Reply. |